How to change Nissan Altima cabin air filter location. This is for Nissan altima from 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014.
To have access and to replace the cabin air filter on a Nissan Altima follow the next instruction.
Locate and change 1999-2001 Nissan Altima cabin air filter.
- In first step you need to remove door seal, remove lower finisher remove screws from glove compartment and then remove glove compartment.
- Remove clip on tab, remove first filter and after that slide second filter down and then out.
- Replace filters in reverse order and reassemble.
Locate and change 2002-2006 Nissan Altima cabin air filter.
- Open glove compartment and remove hinge pins.
- Unsnap retainer cord from glove compartment.
- Remove glove compartment, remove glove compartment frame and then remove filter housing cover
- Replace filter and reassemble.
Locate and change 2007-2014 Nissan Altima cabin air filter.
- Open passenger side door.
- Unsnap and remove left access panel located under glove compartment, unsnap and remove right access panel.
- Remove screws on bottom of glove compartment.
- Open glove compartment, remove screws on top and inside of glove compartment.
- Remove glove compartmentand remove filter housing cover.
- Replace filter and reassemble.
For more guidance feel free to ask about how to replace the air conditioning filter for Nissan Altima.
Find more information about where is located cabin air filter or air conditioning filter for Nissan.
How to locate if you need to change cabin air filter, oil filter, fuel filter, pollen filter, dust filter or air filter on Nissan Altima.
Pictures can be different from one car to another but the procedure is the same.
Why is necessary to replace the cabin air filter? Is necessary to replace this filter to protect you and your passenger from bad odors, some allergen, from pollen and is very important if somebody from your car is allergic to pollen, dust and other particle.
Directions are very spotty. Why do they assume that everyone is automatically going to know how to snap and remove the access panels? It might be “obvious” to you but it was not all all “obvious” to me. If i can’t even figure out how to get started, the rest of the instructions are essentially rendered useless.
sad but mine was not there at all mis info here.